The 2380 cord is a replacement conductor cord that extends from the 3M™ Workstation Monitor 724 to the static control work surface to be monitored.
Additional Information
This cord does not have a resistor molded into the snap fastener cap. The 2389 cord interconnects two tablemats so they can be monitored while using the 3M™ Wrist Strap Workstation Monitor 724 and the 3M™ Dual Remote Splitter Kit 733. This cord does not have a resister molded into the snap fastener cap at both ends of the cord.
Monitor/Table Mat Replacement Cord, 6 ft. (1.8 m), with 10 mm snap. Extends from the 3M™ Wrist Strap Workstation Monitor 724 to the static control worksurface to be monitored. This cord does not have a resistor molded into the snap fastener cap.
Monitor/Table Mat Interconnect Cord, 10 ft. (3 m), with 10 mm snap. A straight cord with male snap fasteners at each end and no resistors. Used to interconnect two monitored worksurfaces.
Printer-friendly format